Viewing 1 post (of 1 total)
-
Posts
-
Hello everyone,
I have been using the DMD software together with a Carpe Iter and the CI controller, which is no longer available, for some time now.
There is one operating function that I would very much like to see: trip correction is only possible in individual steps, i.e. a single keystroke is required for each partial increase or decrease. It would be very helpful if there was a button programming function that would change the trip up or down continuously or even at an accelerated rate when the button is held down.
I look forward to your feedback.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
